Xerox DocuCentre-III C4100 Manual page 376

14 Problem Solving
Error Code
C P F S M O
016-711
016-712
016-713
016-714
016-716
016-717
016-718
14
016-719
016-720
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
374
Category
O O [Cause]
[Remedy] Take one of the following measures, and then try sending
O [Cause]
[Remedy] Increase the resolution or scan area.
O [Cause]
[Remedy] Input the correct passcode.
O [Cause]
[Remedy] Create a new mailbox or specify an existing mailbox.
O [Cause]
[Remedy] Remove unnecessary documents and users from the
Refer to "9 Job Status" > "Printing and Deleting Stored Documents" in the
User Guide.
O [Cause]
[Remedy] Take one of the following actions:
O [Cause]
[Remedy] Reduce the resolution, or cancel 2-sided printing or N up,
O [Cause]
[Remedy] Increase the size of the print page buffer.
O [Cause]
[Remedy] Check the print data and try to print again.
Cause and Remedy
The upper limit for the e-mail size has been exceeded.
the mail again.
Reduce the number of sheets of the document.
Lower the resolution with [Resolution].
Reduce the magnification with [Reduce/Enlarge].
Ask the machine administrator to increase the value set
for [Maximum E-mail Size].
Unable to process, because the specified document area
is too small.
The input passcode does not agree with the passcode set
to the mailbox.
The specified mailbox does not exist.
Unable to spool TIFF file due to insufficient hard disk
space.
machine, and then install an HDD Extension Kit. For
information on installing an HDD Extension Kit, contact our
Customer Support Center.
Unable to create a "transmission report (undelivered)" or
"transmission report" because transmission result
information required for creating the report is not stored in
the machine's memory.
Execute the jobs for large size Internet Fax documents
(about 2GB) by splitting each document to minimize
memory or HDD usage.
If many scan or Internet Fax documents are being
processed, wait to execute a new job until the jobs are
completed.
After the job that you want to check in a report is
completed, do not execute 200 or more jobs to have the
job recorded on a report.
Unable to process the PCL print data due to insufficient
memory.
and then print again.
Unable to process the PCL print data due to insufficient
print page buffer.
An invalid command is included in PCL print data.