Installation When Using Tcp/Ip (Lpd/Port 9100); Step 1 Preparations; Step 2 Configuration On The Machine - Xerox DocuCentre-III C4100 Manual

Installation When Using TCP/IP (LPD/Port 9100)

This section describes how to install the machine by using TCP/IP.
The following shows the reference section for each item.

Step 1 Preparations................................................................................................................... 229

Step 2 Configuration on the Machine ...................................................................................... 229

Step 3 Configuration on the Computer .................................................................................... 230
CentreWare Internet Services Setting Items ............................................................................ 230
Step 1 Preparations
Prepare the following items to install the machine when using a TCP/IP (LPD/Port
9100) protocol.
TCP/IP network environment
CD-ROM of the Driver CD Kit (provided with the machine)
Adobe PostScript 3 Kit (optional) - this is required only when using a Macintosh
computer
Step 2 Configuration on the Machine
The following describes the configuration procedure to use a TCP/IP (LPD/Port 9100)
protocol on the machine. Enable a LPD Port/Port 9100 port, then assign an IP address.
Note • The configuration can also be performed using CentreWare Internet Services or IP Address
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet
Services Setting Items" (P.230).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or a keyboard,
and select [Enter].
When a passcode is required, select [Next Input] and enter the system
administrator's passcode, then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools].
2
Enable either the LPD port or the Port 9100 port as appropriate.
In this example, the LPD port is enabled.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [LPD], and select [Change Settings].
4) Select [Port Status], and select [Change Settings].
5) Select [Enabled], then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the others.
If an IP address is already set, this step is not necessary.
Setting Tool included in the CD-ROM of the Driver CD Kit.

Installation When Using TCP/IP (LPD/Port 9100)

7
229