Xerox DocuCentre-III C4100 Manual page 426

14 Problem Solving
Error Code
C P F S M O
116-790
123-207
123-209
123-400
124-701
124-702
124-705 O
124-706
O
124-708 O
124-709 O
124-710
14
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
424
Category
O [Cause]
[Remedy] For Cause 1. Manually staple the first set of the document.
O [Cause] A malfunction occurred in the machine.
[Remedy] Turn the machine off and on. If the error persists, contact
O [Cause]
[Remedy] Contact our Customer Support Center. Any trays other
O [Cause]
[Remedy] Contact our Customer Support Center. Any trays other
[Cause]
[Remedy] Check the punch position, and try again.
[Cause]
[Remedy] Check the folding setting, and try to print again.
[Cause]
[Remedy] Check if the specified size paper has been loaded in a
[Cause]
[Remedy] Reduce the number of pages, or cancel the stapling
O [Cause] The output destination was changed from the mailbox
[Remedy] Specify the paper size that the mailbox supports.
Cause and Remedy
1. If the operator cancelled printing a document that was
received using the Fax to Mailbox or Internet Fax to
Mailbox feature:
The first set of the document is not stapled.
2. For a cause other than Cause 1:
All the sets of the document are not stapled.
Or, do not cancel printing a document that is received
using the Fax to Mailbox or Internet Fax to Mailbox
feature.
For Cause 2. Check if the staple position has been
correctly specified, and try printing again.
our Customer Support Center.
The output destination was changed to the center tray due
to the malfunction of the specified output tray (Side tray).
than the defective output tray can be used.
The output destination was changed to the center tray due
to the malfunction of the specified Finisher tray.
than the defective output tray can be used.
The punch setting was cancelled.
The folding setting was cancelled.
The output tray was changed to the center tray because
the size of the paper used was different from the size
specified for the 2-Sided feature.
paper tray.
The document exceeded the maximum number of pages
that can be stapled.
setting, then try to print again.
because the mailbox does not support the specified paper
size.