Xerox DocuCentre-III C4100 Manual page 378

14 Problem Solving
Error Code
C P F S M O
016-729
016-731
016-732
016-733
016-734
016-735
016-736
016-737
016-741
016-742
016-743
016-744
016-745
14
016-746
016-747 O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
376
Category
O [Cause]
[Remedy] Change the number of colors/resolution for the TIFF file,
O [Cause]
[Remedy] Retry printing.
O [Cause]
[Remedy] Resend the form data.
O O [Cause]
[Remedy] For Cause 1: Check the e-mail address.
O [Cause]
[Remedy] Set the e-mail reception setting to [STMP reception] on the
O O [Cause]
[Remedy] Retry printing after waiting for a while.
O [Cause]
[Remedy] Take one of the following actions:
O [Cause]
[Remedy] Delete ".LCK" file from the forwarding destination
O [Cause]
[Remedy] Turn the machine off and on. If the problem persists,
O [Cause]
[Remedy] Print using a print driver.
[Cause]
[Remedy] Take one of the following actions:
Cause and Remedy
Unable to print because the number of colors or the
resolution of the TIFF file is out of allowed range.
and try again.
Unable to print TIFF data because it was interrupted.
The form specified by the emulation has not been
registered at the host side.
1. Unable to obtain the IP address (the string after "@" in
the destination e-mail address) when sending e-mail.
2. Unable to resolve the Internet address (the string after
"@") by the DNS server when sending e-mail.
For Cause 2: Check the DNS server address.
Failed to print the simple address result report.
sender's machine.
Attempted to print [Job Template List] while updating the
job template.
Any data cannot be saved in the forwarding destination
directory.
1. Check the free space of the forwarding destination disk.
2. Check to see whether you have privileges for the
forwarding destination directory.
3. Delete a ".LCK" file from the forwarding destination
directory.
Any data cannot be saved in the forwarding destination
directory.
directory.
An error occurred during the update process of the
machine.
contact our Customer Support Center or your dealer.
An unsupported feature is included in the received PDF.
The memory became insufficient when using both the
[Repeat Image] and [Annotations] features
simultaneously.
Use the bigger annotation image size.
Use less [Repeat Image].
Increase memory.