Table of Contents
Advertisement
9.
Grasp the waste toner bottle with your other
hand as shown in the illustration, and pull it
out of the printer.
Important
• Take care to avoid dropping the waste toner bottle while
you are removing it.
10. Insert the used waste toner bottle into the
plastic bag that comes with the new waste
toner bottle and seal the bag.
11. Insert the new waste toner bottle into the slot
and press it in as far as it will go.
12. Close the front cover.
Replacing the Fuser Unit
The following messages appear on the printer's
control panel when the fuser unit is near or
reaches the end of its service life. When replacing
the fuser unit, also replace the transfer belt
cleaner.
Note
• For instructions on replacing the transfer belt cleaner,
refer to "Replacing the Transfer Belt Cleaner" (P. 79).
Message
Ready to print
The fuser unit needs to be
replaced soon. There is
Replace Fuser R8
enough capacity to print
• Fuser Cartridge R8
needs to be
approximately 10,000
replaced soon.
pages.
Order a new
Fuser Cartridge.
Ready to print
The fuser unit has reached
the end of its replacement life.
Replace Fuser R8
Refer to "Replacement
• Replace Fuser
Procedure" (P. 77) when
Cartridge R8.
replacing the fuser unit and
then refer to "Resetting the
Counter" (P. 79) to clear the
counter.
*1
: The page yield of each consumable varies
depending on print requests, documents printed,
and how often the power is switched on/off. For
more information, refer to "Life of Consumables
and Regular Replacement Parts" (P. 82).
Replacement Procedure
CAUTION
Fuser Safety
• When removing the fuser unit, always switch
off first and wait for 40 minutes until it cools off.
1.
Switch the power off by pressing the <
side of the power switch.
Replacing the Fuser Unit
Action
*1
>
77
Advertisement
Table of Contents
