Xerox DocuCentre-III C4100 Manual page 415

Category
Error Code
C P F S M O
034-508
O
034-509
034-510
034-511
O
034-512
O
034-515
O
034-519
O
034-520 O
034-521
O
034-522
O
034-523
O
034-527
O
034-528
O
034-529
O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
Cause and Remedy
[Cause] An error occurred during fax transmission.
[Remedy] Check the settings and the phone number, and send the
fax again. If the error persists, contact our Customer
Support Center.
[Cause] A document for relay broadcasting cannot be transmitted.
[Remedy] Select [Address Book] to print an address list, and check if
the relay station is correctly registered. If the registered
address is incorrect, modify it. Check also the contents of
the address number registered at the relay station.
For information on Relay Broadcast, refer to "4 Fax" > "Broadcast" in the
User Guide.
For information on Remote Relay Broadcast, refer to "4 Fax" > "Broadcast"
in the User Guide.
[Cause] An infinite loop was detected on the remote relay
broadcast.
[Remedy] Check the abbreviated number of the relay broadcast.
Check also the abbreviated number registered in the relay
station.
For information on Remote Relay Broadcast, refer to "4 Fax" > "Broadcast"
in the User Guide.
[Cause] The destination machine has a problem.
[Remedy] Check the conditions of the destination machine.
[Cause] The number of destinations specified for the broadcast
transmission exceeded the upper limit.
[Remedy] Wait until the waiting jobs decrease, or reduce the number
of destinations, and try again.
[Cause] The number of waiting jobs exceeded the upper limit.
[Remedy] Wait until the waiting jobs decrease, and try again.
[Cause] An error occurred while faxing.
[Remedy] Turn off and on the machine. If the error persists, contact
our Customer Support Center.
[Cause] There is no line available for the manual communication.
[Remedy] Wait until the job in communication is completed, and try
again.
[Cause] Unable to accept jobs.
[Remedy] Retry after waiting for a while.
[Cause] An error occurred while faxing.
[Remedy] Turn off and on the machine. If the error persists, contact
our Customer Support Center.
[Cause] Manual communication is not available during dialing.
[Remedy] Try again after the dialing.
[Cause] Paper with the same size as the received document is not
loaded on the machine.
[Remedy] Check the following:
Check the sizes of paper loaded on the machine.
Check if the paper trays are correctly inserted.
Error Code
14
413