Audio Tones; Power Saver/Energy Saver Timers; Control Panel Select Tone - Xerox DocuCentre-III C4100 Manual

5 Tools

Power Saver/Energy Saver Timers

The machine is provided with the Low Power and Sleep modes as the power saving mode.
When a specified period of time has elapsed, the machine switches to these modes in the
following order to reduce power consumption.
Last operation on the machine
For more information, refer to "Energy Saver Mode" (P.18).
Note
From Last Operation to Low Power Mode
Specify a time period between the last operation and entering the Low Power mode in the
range from 1 to 240 minutes, in 1 minute increments.
From Last Operation to Sleep Mode
Specify a time period between the last operation and entering the Sleep mode from 1 to 240
minutes, in 1 minute increments.
Note

Audio Tones

5
Select whether or not to sound an alarm, for example when a job ends or a fault occurs.

Control Panel Select Tone

Select the sound to be made when a button displayed on the screen is correctly selected.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Control Panel Alert Tone
Select the sound to be made when a button that cannot be selected is selected, or an error
occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Machine Ready Tone
Set the sound for when the machine is ready to copy or print, after powering on, for example.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Job Complete Tone 1, 2
Select the sound to be made when a job is completed normally.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
You can select the target jobs.
Fault Tone
Select the sound to be made when an error termination occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
108
• The print-disabled condition is cancelled when you operate using the control panel after the
ending time.
• To enable printing during the printer lockout duration, select a job under [Active Jobs] on the
[Job Status] screen, and then select [Promote Job].
Low Power mode
• There is no setting to disable switching to the Low Power mode or the Sleep mode.
• Configure the [From Last Operation to Sleep Mode] time to be longer than the [From Last
Operation to Low Power Mode] time.
Sleep mode