Table of Contents
Advertisement
7. M a i nt en a nc e
Replacing the Fuser Web Assembly
7- 1 6
5.
Carefully insert the Filler Spout into the opened Fuser Oil
Reservoir and squeeze the bottle until the oil reaches the
maximum fill level tab visible inside the Reservoir.
6.
Remove the Filler Cap from the bottle and place it on a cloth
or paper towel to drain. Return the original cap to the bottle
of Fuser Oil.
7.
Close the Reservoir Cap, ensuring that it snaps into place.
8.
Close the Right Front Door of the digital press.
Two messages will display on the UI regarding the Fuser Web.
The first advises you that the web is almost used up and you
should be sure to have a new unit on hand. The second message
displays when the Fuser Web is completely used and you must
replace it. When this message displays, the digital press shuts
down and will not print until the web is replaced.
WARNING: The Fuser area is hot. Be careful when working in this
area to avoid injury.
Use the following procedure to replace the Fuser Web.
1.
Open the front doors of the digital press.
Front Doors
Do c uC o lo r 50 0 0A P Us e r G ui d e
Advertisement
Table of Contents
