Xerox DocuCentre-III C4100 Manual page 413

Category
Error Code
C P F S M O
033-728
O
033-731
O
033-733
O
033-734
O
033-735
O
033-736 O
033-737
O
033-738
O
033-740 O
033-741
O
033-742
O
033-743
O
033-744
033-745
033-746
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
Cause and Remedy
[Cause] The Auto Print formatting of the received fax document
was interrupted by a manual print operation.
[Remedy] No operation is necessary. The machine will automatically
start the Auto Print job after manual printing.
[Cause] The print job for the received fax document was
interrupted.
[Remedy] The Auto Print processing of the received fax document
was interrupted by a manual print operation. No operation
is necessary.
[Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
[Cause] The print job of the received fax document was interrupted
by a report job.
[Remedy] No operation is necessary.
[Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the error persists, contact
our Customer Support Center.
[Cause] The forwarding job was interrupted because the data
volume exceeded the upper limit.
[Remedy] No operation is necessary.
[Cause] An error occurred during fax transmission.
[Remedy] Try again. If the error persists, contact our Customer
Support Center.
[Cause] Received abnormal JBIG data.
[Remedy] No operation is necessary.
[Cause] The print job for the received fax document was
interrupted.
[Remedy] No operation is necessary.
[Cause] An error occurred during fax transmission.
[Remedy] Try again. If the error persists, contact our Customer
Support Center.
[Cause] An error occurred during fax transmission. This error may
occur if the remaining capacity of the machine's memory is
10% or less and Manual Send is used.
[Remedy] When this error was caused by Manual Send, connect the
line after storing the document. If the error is still not
cleared, remove unnecessary data from the hard disk to
increase free disk space, and retry again.
Try again. If the error persists, contact our Customer
Support Center.
[Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. Try again. If the error
persists, contact our Customer Support Center.
Error Code
14
411