Replacing The Staple Cartridge (For Booklet Maker Unit For Finisher-B1) - Xerox DocuCentre-III C4100 Manual

3 Maintenance
5
Insert the front side of the new
staple case into the staple cartridge
(1), and then push the rear side
into the cartridge (2).
6
Hold the staple cartridge by the
orange lever, and insert it into the
finisher until it clicks.
3
7
Close the front cover of the finisher.
Note

Replacing the Staple Cartridge (for Booklet Maker Unit for Finisher-B1)

When the Booklet Maker Unit for Finisher-B1 (optional) is installed and it is time to
replace the staple cartridge, a message appears on the touch screen. When this
message appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
Note
1
Make sure that the machine is not
operating, and open the side cover
of the finisher.
2
Hold the tabs on both sides of the
staple cartridge and pull the
cartridge out of the finisher.
58
• If the front cover of the finisher is not completely closed, a message will appear and the
machine will not operate.
performance. Use only staple cartridges recommended by Fuji Xerox for the machine.
• To order a staple cartridge, contact our Customer Support Center.
2
1