Xerox DocuCentre-III C4100 Manual page 424

14 Problem Solving
Error Code
C P F S M O
077-215
078-210
078-211
078-250
081-799
112-700
116-220
116-324
116-701
O O
116-702
116-703
14
116-710
116-713
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
422
Category
O [Cause]
[Remedy] Contact our Customer Support Center.
O [Cause]
[Remedy] Power-cycle the machine. If the problem persists, contact
O [Cause]
[Remedy] Power-cycle the machine. If the problem persists, contact
O [Cause]
[Remedy] Power-cycle the machine. Contact our Customer Support
O [Cause]
[Remedy] Contact our Customer Support Center. Trays other than
O [Cause]
[Remedy] Empty the punch waste container.
O [Cause]
[Remedy] Contact our Customer Support Center.
O [Cause]
[Remedy] If an error occurred while printing, turn off the machine
[Cause]
[Remedy] Add memory.
O [Cause]
[Remedy] Check the print data.
O [Cause]
[Remedy] Either check the print data, or click [Spool Settings] on the
O [Cause]
[Remedy] Increase the size assigned to HP-GL/2 auto-layout
O [Cause]
[Remedy] Remove unnecessary data from the hard disk to increase
Cause and Remedy
The machine detected a different type of paper tray being
attached.
Tray 2 (High Capacity) malfunction
our Customer Support Center. The other trays are
available.
Tray 3 (High Capacity) malfunction
our Customer Support Center. The other trays are
available.
An error occurred when using the High Capacity Feeder.
Center.
Tray 1 malfunction
the Tray 1 can be used.
The finisher's punch waste container is full.
Failed to move to the Download mode.
An error occurred on the machine.
once, then hold down both the <Start> and <Stop> buttons
simultaneously for 6 seconds when turning the machine
back on. This will delete the print data which caused the
error. If the error was caused by other reasons, turn the
machine off and on. If the problem persists, contact our
Customer Support Center.
Unable to use the 2-sided printing feature due to
insufficient memory.
A print job was processed using a substitute font.
An error occurred during PostScript (optional) processing.
[Details] tab in the print driver to set bi-directional
communication to off.
A probable cause is that the correct document size could
not be judged as the receive data exceeded the HP-GL/2
spool size.
memory.
The job was divided to be printed due to insufficient disk
space.
free disk space.