Xerox DocuCentre-III C4100 Manual page 410

14 Problem Solving
Error Code
C P F S M O
027-744
027-745
027-746
027-750
027-751
027-752
027-753
027-754
14
027-770
027-771
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
408
Category
O O [Cause]
[Remedy] Make sure that the DNS server connection and the domain
O O [Cause]
[Remedy] Either register the address of the DNS server on the
O O [Cause]
[Remedy] Set up the correct port.
O [Cause]
[Remedy] Fax/print/Internet Fax features are unavailable for scan
O [Cause]
[Remedy] Check the settings of the job flow.
O [Cause]
[Remedy] Take one of the following actions:
O [Cause]
[Remedy] For Cause 1) Have your System Administrator check the
O [Cause]
[Remedy] Check the DocuWorks and PDF signatures for both the
O [Cause]
[Remedy] Submit a print job again.
O [Cause]
[Remedy] Delete unnecessary data from the server.
Cause and Remedy
The domain name of the job template pool server has a
problem.
name have been registered to the DNS server.
The address of the DNS server has not been registered on
the machine.
machine, or set the address of the job template pool server
with its IP address.
The protocol settings on the job template pool server are
incorrect.
Attempted to give a fax/print/Internet Fax command to the
scan document.
documents. Set the job flow correctly.
An error occurred during job flow processing.
A mandatory entry field is blank in the job flow.
Link mailboxes only to job flows that do not have
mandatory entry fields.
Set the default values to the mandatory fields of the job
flow.
1) Attempted to execute the service while the port
necessary for the job flow is either deactivated or disabled.
2) Attempted to execute a job flow to send e-mail using the
encryption or digital signature feature while S/MIME
communication is disabled.
port status.
For Cause 2)Enable S/MIME communication, or modify
the job flow so that e-mail is sent by not using the
encryption or digital signature feature.
The setting contents for [DocuWorks Signature] or [PDF
Signature] on the job flow are not appropriate.
system data settings (machine's current settings) and the
executed job flow settings. If these settings are not the
same, change either of them.
The print job has a problem.
The hard disk of the server connected to the machine is
full.