Removal 18 Right Arm Assembly(Pl7.1.98) - Dell 3110cn Service Manual

Removal 18 RIGHT ARM ASSEMBLY(PL7.1.98)

Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 12)
4) Remove the RIGHT COVER. (Removal 13)
5) Release the hook of the SHAFT PIVOT (PL1.2.8) that fixes the LINK R (PL7.1.13) to the
FRONT COVER (PL1.2.1), an then pull the SHAFT PIVOT to the outside and remove the
LINK R from the FRONT COVER.
6) Remove threescrews (silver, tap, 8mm) that fix the SUPPORT LINK R (PL7.1.12) to the
printer.
7) Remove the SUPPORT LINK R from the printer.
Continues to the next page.
Version 3 2007.03.15
Chapter 3 Removal and Replacement Procedures (RRPs)
5)-3
5)-2
5)-1
3 - 36
6)
7) 6)
6)
Kmy03027KA