Removal 54 Right Cover (Pl13.1.9) - Dell 3115cn Service Manual

Removal 54 RIGHT COVER (PL13.1.9)

Steps 1 through 6 are for reference. Before removing this component, check that Steps 1 through 6
have been performed.
1) Open the FRONT COVER (PL13.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 49)
4) Remove the COVER BOTTOM. (Removal 50)
5) Remove the COVER POLE IN R. (Removal 51)
6) Remove the COVER POLE R. (Removal 52)
7) Remove the two screws (silver, tap, 10mm) and the two screws (silver, 6mm) that fix the
RIGHT COVER (PL13.1.9) to the printer.
8) Release the holes on the screw mounting positions on the top side of the RIGHT COVER from
the bosses on the printer.
9) Release from the printer the one hook on the rear side of the RIGHT COVER by sliding the
rear of the RIGHT COVER slightly outward.
10) Release from the printer the two hooks on the front section of the RIGHT COVER by sliding
the RIGHT COVER diagonally backward, and then remove the RIGHT COVER from the
printer.
Go to the next removal steps:
Removal 14 MPF FEED SOLENOID (PL3.1.98), Removal 15 FEED DRIVE ASSEMBLY
(PL8.1.7), Removal 18 RIGHT ARM ASSEMBLY (PL13.3.98), Removal 19 SIZE SWITCH
ASSEMBLY (PL7.1.18), Removal 21 TONER CARTRIDGE SENSOR ASSEMBLY (C), (M),
(Y) (PL5.1.4) , Removal 55 FRONT COVER (PL13.2.98), Removal 56 OPERATOR PANEL
(PL13.2.97) or Removal 57 COVER POLE IN L (PL13.1.3)
Version 2 2007.03.20
Chapter 3 Removal and Replacement Procedures (RRPs)
9)-2
7)
8)
10)-1
10)-1
7)
3 - 78
7)
9)-1
7)
10)-2
Gnb03159KA