Communicating To The Terminal Interface; Connecting To Terminal Interface Via Diagnostics Connector - Dialogic DMG1000 User Manual

Diagnostics
Important points to remember about TDM Capture are:
• For proper downloading you must right click on Download tdmlog.wav file.
Note: A right click is necessary due to the Windows
• TDM capture occurs regardless of channel call state.
• Capture times
– Rx only = ~ 48 minutes (data into DMG2000)
– Rx & Tx = ~ 24 minutes
Downloading does not require any special software, but viewing requires an audio viewer such
•
as CoolEdit Pro or Adobe Audition (not freeware).
• Downloading the TDM Capture clears the log and starts another.
• Stopping the log and restarting clears the log. Caution: This operation is different from the
other logs.
9.5

Communicating to the Terminal Interface

Provided you have Admin level privileges, you may communicate with the Media Gateway
terminal interface by connecting to the serial interface (DIAGNOSTICS connector on DMG1000
types and COM2 connector on DMG2000 types) located on the rear panel or by establishing a
telnet session via the LAN port.
Information in this section includes:
•

Connecting to Terminal Interface Via DIAGNOSTICS Connector

Connecting to Terminal Interface Via LAN Connector
•
9.5.1 Connecting to Terminal Interface Via DIAGNOSTICS
Connector
Perform the following:
1. Connect a serial cable to the serial interface connector on the rear panel of the Media Gateway.
For connector pin designation information, refer to the DIAGNOSTICS Connector Pin
Designations table (DMG1000) or COM1 and COM2 Connector Pin Designations table
(DMG2000) in the Getting Started Guide.
2. Using a standard serial interface application (for example, Procomm Plus or HyperTerminal),
set the workstation to the following:
Baud Rate = 38400 for DMG1000, 115200 for DMG2000
•
• Parity = None
Data Bits = 8
•
• Stop Bits = 1
Hardware Flow Control = Off
•
222
Windows Media Player. Said mapping results in a left click automatically bringing up
Windows Media Player, which does not allow for saving a file.
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
®
OS mapping the .wav extension to
Dialogic Corporation