Display Translation Descriptors - Dialogic DMG1000 User Manual

Figure 32. Default Mitel Digital CPID Configuration Data (cpid.htm)
The parser attempts to match an input integration or display string to a rule defined by the
configuration data. If a match is made, the parser uses the call-party, reason code, and origin
specifiers of the matching rule. In this manner, the parser can extract the call party information
from the correct locations of the integration or display strings.
6.2.1

Display Translation Descriptors

Translation descriptors define translations between telephone switch-specific display tokens and
strings that the application uses. Translation descriptors are global translations that govern all
display parsing rules. The following is a reason code example.
trans reason |FWD|fwd-all
The above provides a translation of the switch-specific reason code "FWD" to the application string
"fwd-all". If the token "FWD" is found in the reason-code section of a display, the reason code
presented to the application will be "fwd-all". This provides a means of normalizing different
switch-specific reason codes into strings that can be recognized by the application. The following is
an origin example.
trans origin |default|internal
If the switch-specific code is 'default', then the application string of the translation is set as the
default translation result if no switch-specific string is found. In the above case, the default call
origin for all displays is 'internal'.
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
Media Gateway Parsers
167