Parameter Reference
Destination for Un-routable PBX Calls
Description: Specifies the PBX extension number to which un-routable PBX-To-IP calls will be
transferred.
Allowed Values:
•
Any valid dialable number string (0 to 7 characters).
If blank (none), then un-routable calls are ignored/dropped.
•
Default Value = (no default value)
INI File Parameter Name = gwDefaultPBXCallDest
Monitor Call Connections
Description: When the Monitor Call Connections parameter is enabled (set to "Yes"), the Media
Gateway will monitor the connection state of active IP calls. If the active IP call has lost
connection, the Media Gateway will tear down the call.
Note: If enabled in SIP, the IP endpoints must support session timers. If enabled in H.323, the IP
endpoints must support Real-Time-Delay requests.
Note: H.323 is only supported in Version 5.1 SU1 Software or earlier.
Allowed Values:
•
Yes = the Media Gateway monitors the connection state of active IP calls.
•
No = the Media Gateway does not monitor the connection state of active IP calls.
Default Value = No
INI File Parameter Name = gwMonitorCallConns
Call Monitor Interval
Description: Specifies the call monitor interval in seconds at which active IP calls are monitored in
order to determine the connections status. This parameter is only valid if the Monitor Call
Connections parameter is enabled.
Allowed Values: 30 through 3600 seconds
Default Value = 60
INI File Parameter Name = gwMonitorCallIntSec
3.6.2.2
Telephony Group
The Telephony subgroup includes the following parameters:
•
Minimum Call Party Delay (Phone Emulating Only)
70
®
Dialogic
1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation