Dialogic DMG1000 User Manual page 216

Diagnostics
Figure 56 shows the default trace keys (i.e. immediately after power-up). Notice the Error and
Debug trace masks are not shown as they are always enabled.
To use the Debug Trace Capture, first check the appropriate trace masks. Click Apply Masks and
then click Start Logging. Logging starts and the display changes to show the state of the log. An
example of a running log is shown in Figure 57.
Figure 57. Example of a Running Log - Debug Trace Capture
When the Debug Trace Capture is running, the fill level of the log is displayed. The log uses a
circular buffer, so when it reaches capacity, new data overwrites the old. Once the log reaches
capacity, the fill level does not change.
216
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation