Configuration Options - Dialogic DMG1000 User Manual

Figure 40. VoIP Interface Web Page
9.1.2.1

Configuration Options

The following configuration items are available to be modified by the user:
Test Selection
Choose the type of diagnostic test to perform. Available options are Initiate Call and Send
Message Waiting Status.
Destination VoIP Address
The required address of the VoIP endpoint that the diagnostic test will use when attempting to
establish a connection. If this configuration is empty the diagnostic test will not be performed.
Source Name
The alphanumeric name representing the source party that is delivered to the destination
endpoint during the diagnostic test. This is an optional field that is not required to perform the
diagnostic test.
Source Number
The number representing the source party that is delivered to the destination endpoint during
the diagnostic test. This is an optional field that is not required to perform the diagnostic test.
Messages Waiting Status
Choose the status value of the message waiting notification update. This field is only valid
when the Message Waiting diagnostic test is selected.
9.1.2.2 Test Status
When a diagnostic test is executed the test results are shown in the VoIP Interface Test Status table
on the Web page.
The test can be canceled at any time by pressing the Cancel Test button.
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
Diagnostics
197