Validating Call Progress Tones; Validate Tone Progress Web Page - Dialogic DMG1000 User Manual

Working with Call Progress Tones
4.2.5

Validating Call Progress Tones

If the timing and frequency information is available and the desire is to only validate the
information, then use the Validate Only button. The Media Gateway will dial a destination address
where the call progress tone to be tested can be heard. The unit will then call each destination
address and determine if the specified call progress tone is detected.
The validation process is useful when there was an error in learning new tones and some tone
characteristics have been manually adjusted to remove conflicts. The Validate Only button can be
used to validate the changes.
Follow these steps to validate the timing and frequency characteristics of call progress tones.
1. For each call progress tone that is to be validated, determine how that tone can be generated by
the system.
2. Verify that the system will generate the call progress tone that is desired by dialing that
destination address from an extension and listening to verify the tone.
3. Navigate to the Learn Tone Web page (see Figure 9) and enter the destination addresses for the
tones to be learned.
4. Click on the Validate Only button.
5. Wait for the Validate Tone Results page to be displayed (see Figure 14 and Figure 15). A
progress page will be displayed (see Figure 13) showing progress messages as the system
proceeds.
4.2.6

Validate Tone Progress Web Page

Once the Validate Only button has been selected, the Media Gateway will start the process of
validating the call progress tone. A progress page, shown in Figure 13, will automatically appear
while the Gateway is validating the tones and progress messages will be posted.
144
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation