Dialogic DMG1000 User Manual page 98

Parameter Reference
Default Value =CRC_FMF
INI File Parameter Name = e1Framing
Note: Unit requires a restart if this parameter value is changed.
3.7.4.5 Selects Transmit Pulse Waveform
Description: Selects the method to be used for generating the Transmit Waveform Shape.
Allowed Values:
• 75_Ohm = 75 ohm (unbalanced) impedance is used.
• 120_Ohm = 120 ohm (balanced) impedance is used.
Default Value = 75 Ohm Impedance
INI File Parameter Name = e1TxWave
Note: Unit requires a restart if this parameter value is changed.
3.7.4.6 Contiguous B-Channel
Description: Specifies B-Channel Selection Mode Used By Switch. Only applicable to E1 ISDN
protocols.
Allowed Values:
• Yes = Contiguous B-Channel Selection (logical mapping).
No = Skip B-Channel 16 (physical mapping)
•
Default Value = No
INI File Parameter Name = e1ContiguousBchan
3.7.4.7 Outbound TDM Calling Party Source
Description: The source of the calling party that will be provided to the TDM interface for
outbound calls and MWI requests.
Note: When a DMG2000 is connected to a Mitel PBX and is configured for E1 QSIG, this parameter
must be set to one of the following options in conjunction with the Static TDM Calling Party
parameter:
Outbound TDM Calling Party Source set to Static and Static TDM Calling Party set to a
•
number (e.g. 1234).
• Outbound TDM Calling Party Source set to VoIP and the VoIP endpoint must provide a
calling party number in the VoIP call/MWI call request.
• Outbound TDM Calling Party Source set to VoIP_Preferred and Static TDM Calling Party set
to a number (e.g. 1234).
98
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation