Table of Contents
Advertisement
®
™
Dialogic
BorderNet
500 Gateways Installation and Configuration Guide
Accessing the Dialogic
To access the Diva SIPcontrol web interface from the SIParator web interface, follow these steps:
1. Click Dialogic BRI/PRI on the main menu of the SIParator web interface:
The Diva SIPcontrol web interface password screen appears.
2. Log in using the password for the Diva SIPcontrol web interface. The default password is Dialogic.
The main Diva SIPcontrol web interface page appears.
Note: Changes to the Diva SIPcontrol configuration will only take effect after you click Save at the bottom of
the main configuration page. All settings are lost if you close the Diva SIPcontrol web interface without saving
the configuration.
Setting Up Access to the Dialogic
Setting up access to the BorderNet 500 Configuration involves configuring the network interfaces and configuring
access control.
Configuring the Network Interfaces
Configure the network interfaces by assigning an IP address to the BorderNet 500 Gateway, giving each computer
in the network a network name, and optionally defining groups of computers and networks. Every group of
computers that can reach each other without having to pass through the firewall needs a separate network group.
To configure the network interfaces, follow these steps:
1. Click Network on the main menu of the SIParator web interface.
The Network page appears.
2. Click Eth0 on the Network page:
The Eth0 network options appear.
3. In the Directly Connected Networks section, enter the IP address of the BorderNet 500 Gateway on the
physical Ethernet connection. For example:
Page 24
™
®
®
Diva
SIPcontrol
®
BorderNet™ 500 Gateway Configuration
Web Interface from the SIParator Web Interface
Advertisement
Table of Contents
