Serial Protocol Parameters - Dialogic DMG1000 User Manual

Parameter Reference
3.4.4.7 Central Office (Type I) FSK Caller ID Timeout
Description: Specifies the duration in milliseconds that the digital signal processor (DSP) will
perform FSK Type I Caller ID detection after an alert is detected. This configuration option is only
enabled when the Central Office Caller ID Type is Bellcore FSK and the Caller ID Alert Type is
other than None.
Allowed Values: 500 to 30000 milliseconds
Default Value = 5000 milliseconds
INI File Parameter Name = telAlgFskCidTimeoutMs
3.4.4.8 CPID Parsing Configuration
Description: Modifying this data affects either the in-band Type I (on-hook) or Type II (off-hook)
CPID parsing of the DMG1000, depending on how the unit is configured. The text box on this page
can be easily modified by either pasting parsing rules into it from a text file or directly modifying
the contents of the control. See
the creation and use of parsing rules.
3.5

Serial Protocol Parameters

Note: The Serial Protocol Web page does not exist for Mitel or Rolm DMG1000 units.
The Serial Protocol parameters are used to define the serial protocol used in the connection to the
PBX serial link. These parameters include:
Serial Mode (Master/Slave)
•
• Serial Interface Protocol
• MCI Message Extension Length
• MCI Message Type
• CPID Length
CPID Padding String
•
• Voice Mail Port Length
• System Number
• MWI Response Timeout
IP Address of Serial Server
•
• Serial CPID Expiration
• Logical Extension Number
62
Chapter 6, "Media Gateway Parsers"
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
for further information about
Dialogic Corporation