Diagnostic Commands; Devstat Command; Restart Command; Ping Command - Dialogic DMG1000 User Manual

9.7

Diagnostic Commands

This section describes a number of diagnostic commands and includes:

Devstat Command

•
•

Restart Command

•

Ping Command

• Ver Command
• Alarm List Command
9.7.1 Devstat Command
The Devstat command displays the current high-level settings of the unit and the unit's main status
and telephony port status. The telephony port state can be 'In Service', 'Out of Service', or 'Active'.
'Active' means that the port is off-hook. 'In Service' means that the port is available for use, but is
currently not in use. 'Out of Service' means that the port is disconnected.
PIMG>devstat
Description
======================================================================
sysStartType
MAC
IP
Subnet Mask
Gateway
Host
Status
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
Port 8
9.7.2 Restart Command
The Restart command causes the unit to warm-boot.
restart
9.7.3 Ping Command
The Ping command generates ICMP requests to the specified IP address. This is useful in
determining connection status to IP endpoints, gateways, or routers.
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
Value
0x0
00-a0-e6-02-01-19
10.0.1.110
255.255.255.0
10.0.1.1
10.0.1.63
OK
Active
In Service
In Service
In Service
In Service
In Service
In Service
In Service
Diagnostics
235