Dialogic DMG1000 User Manual page 67

3.6.1.1 Call Routing Group
The Call Routing group includes the following parameters:
• Fault Tolerance Enabled
• Load Balancing Enabled
• VoIP Endpoint ID
Fault Tolerance Enabled
Description: Enables or disables fault-tolerance handling of outbound Voice over IP (VoIP) calls.
If Yes is selected, the Media Gateway will failover to the next configured VoIP endpoint if an
outbound VoIP call attempt fails. If No is selected, then a failed outbound VoIP call attempt will not
be retried.
Allowed Values:
• Yes = Media Gateway will failover to next configured VoIP endpoint if a call attempt fails.
• No = Media Gateway failed call attempt will not be retried.
Default Value = No
INI File Parameter Name = gwFaultToleranceEnabled
Load Balancing Enabled
Description: Enables or disables load-balancing of outbound Voice over IP (VoIP) calls. If Yes is
selected, then the Media Gateway will route outbound VoIP calls to each configured VoIP endpoint
in a round-robin fashion. If No is selected, the Media Gateway will not load-balance across
multiple VoIP endpoints.
Allowed Values:
• Yes = Media Gateway will perform load-balancing on outbound VoIP calls.
• No = Media Gateway will not perform load-balancing on outbound VoIP calls.
Default Value = No
INI File Parameter Name = gwLoadBalanceEnabled
VoIP Endpoint ID
Description: Specifies the IP address of the Voice over IP (VoIP) Server(s) that will receive all
inbound calls from the PBX.
Note: Additional VoIP Servers can be added to the list by pressing the Add New Endpoint button. Each
VoIP Endpoint entered will then be used as part of the Fault Tolerance and/or Load Balancing
schemes as defined by the
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
Fault Tolerance Enabled and
Parameter Reference
Load Balancing Enabled parameters.
67