Trace Default - Dialogic DMG1000 User Manual

Pbn
VoIP
Gw
Gcc
Adept
teldrv
CallLog
Log
Channel Trace State ('*' enabled, '-' disabled)
------------------------------------------------
* * * * * * * *
9.6.3.2

trace default

The trace default command sets the default tracing of all trace keys, and enables VoIP and
telephony event tracing.
PIMG>trace default
9.6.3.3 trace <trace key> <trace type|all> <on|off>
This trace command enables or disables trace types on specified trace keys.
Use:
trace tel all on
to enable all telephony traces
Use:
trace tel event on
to enable telephony control traces
9.6.3.4 trace all <trace type|all> <on|off>
The trace all command enables/disables trace types on all trace keys.
Use:
trace all code off
to disable all code traces on all trace keys
Use:
trace voip code on
to enable code traces only on voip stacks
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
Error Init Debug
Error Init Debug
Error Init Debug
Error Init Debug
Error Init Debug
Error Init Debug
Error Init Debug
Error Init Debug
Diagnostics
229