Cpid Parsing Configuration; H.323 Parameters - Dialogic DMG1000 User Manual

Allowed Values:
• None = No calling party is sent.
• VoIP = Calling party is derived from the VoIP call/mwi-request.
• Static = A statically configured calling party is used.
• VoIP_Preferred = Calling party is derived from the VoIP call/mwi-request. If not available
from VoIP, then the statically configured calling party is used.
Default Value = Static
INI File Parameter Name = gwTdmOutboundCallingPartySrc
3.7.4.8 Static TDM Calling Party
Description: Specifies the calling party that will be provided to the TDM interface if
TDM Calling Party Source
Note: When a DMG2000 is connected to a Mitel PBX and is configured for E1 QSIG, this parameter
must be set to one of the following options in conjunction with the Outbound TDM Calling Party
Source parameter:
Outbound TDM Calling Party Source set to Static and Static TDM Calling Party set to a
•
number (e.g. 1234).
• Outbound TDM Calling Party Source set to VoIP and the VoIP endpoint must provide a
calling party number in the VoIP call/MWI call request.
• Outbound TDM Calling Party Source set to VoIP_Preferred and Static TDM Calling Party set
to a number (e.g. 1234).
Allowed Values: Any valid dialable number
Default Value = 1234
INI File Parameter Name = gwTdmOutboundCallingParty
3.7.5

CPID Parsing Configuration

Description: Modifying this data affects either the in-band Type I (on-hook) or Type II (off-hook)
CPID parsing of the DMG2000, depending on how the unit is configured. The text box on this page
can be easily modified by either pasting parsing rules into it from a text file or directly modifying
the contents of the control. See
the creation and use of parsing rules.
3.8

H.323 Parameters

The H.323 parameters include:
Gatekeeper Mode
•
• Gateway Name
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
is set to Static or VoIP_Preferred.
Chapter 6, "Media Gateway Parsers"
Parameter Reference
Outbound
for further information about
99