3.7
T1/E1 Parameters (DMG2000 Only)
The T1/E1 parameters are used to configure the T1 and E1 port(s) on a DMG2000 and include the
following groups:
T1/E1 Mode Group
•
•
T1 CAS Protocol Group (T1 CAS Signaling Mode)
•
T1 ISDN Protocol Group (ISDN Signaling Mode)
•
E1 ISDN Protocol Group (ISDN Signaling Mode)
CPID Parsing Configuration
•
3.7.1
T1/E1 Mode Group
The parameters in the T1/E1 Mode group include the following:
•
Line Mode
•
Signaling Mode
•
Interface Side
3.7.1.1
Line Mode
Description: Specifies the Line Mode type (T1 or E1) to which the T1/E1 connector will be
interfacing.
Allowed Values:
•
T1 = Interfaces to T1 line (23/24 channels)
E1 = Interfaces to E1 line (30 channels)
•
Default Value = T1
INI File Parameter Name = t1e1LineMode
3.7.1.2
Signaling Mode
Description: Specifies the signaling mode to be used.
Allowed Values:
•
CAS = Channel associated signaling
•
ISDN = Common channel signaling
Default Value = CAS
INI File Parameter Name = t1e1Signaling
Note: Unit requires a restart if this parameter value is changed.
®
Dialogic
1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
Parameter Reference
87