Parameter Reference
the middle frequency is the second frequency, and the bottom frequency is the third frequency. A
value of 0 means to ignore the entry.
Allowed Values: 0-2000 Hz
Default Value = 0
INI File Parameter Name = cpToneFreq
3.11.7
Tone Frequency Deviation
Description: Specifies the deviation for the tone frequencies for this tone definition.
Allowed Values: 0-200 Hz
Default Value = 0
INI File Parameter Name = cpToneFreqDeviation
3.11.8
Tone Cadence Time
Description: Specifies the cadence times for this tone definition. A tone can be described by up to
three (3) cadence times.
The interpretation of each time parameter is dependent on the selection of Cadence Type. For a
given cadence type, Cadence Time specifies the time in milliseconds.
Continuous - The first time value specifies the minimum time on that must elapse before the
•
tone on event is generated.
•
OnOff - The first two time values are used to specify the on time and off time respectively.
•
OnOffQuick - The first time value is used to specify the minimum on time that causes
detection and the second time value specifies the maximum off time that causes a cadence
break.
•
Alternating - The first two time values specify the on time for the corresponding frequency
component.
•
Sequential - For each of the tones in the sequence the corresponding time value specifies the
on-time for the tone.
Allowed Values: 0-10000 ms
Default Value = 1500
INI File Parameter Name = cpToneTime
3.11.9
Tone Cadence Time Deviation
Description: Specifies the deviation for the cadence times for this tone definition.
128
®
Dialogic
1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation