Dialogic DMG1000 User Manual page 61

Allowed Values:
• Bellcore FSK
• DTMF
• None
Default Value = None
INI File Parameter Name = telAlgCoCidType
3.4.4.5 Central Office (Type I) Caller ID Alert Type
Description: Specifies the kind of Type I caller ID alert that is used on the trunk(s) connected to
the DMG1000, either pause in ring cycle, ring burst, polarity reversal, or none. This configuration
option is only enabled when the Central Office (Type I) Caller ID Type is set to Bellcore FSK.
Notes: 1. If the pause in ring cycle alert type is used, the Incoming Rings Before Answer parameter should
be set to greater than 1 for the caller ID information to be contained in the outgoing voice over IP
(VoIP) message.
2. If an alert is used on the trunk that is not explicitly supported in the list (for example, OSI or a
dual tone), use the None setting for this parameter.
Allowed Values:
• Pause in Ring Cycle
• Ring Burst
Polarity Reversal
•
None
•
Default Value = Pause in Ring Cycle
INI File Parameter Name = telAlgCoCidAlertType
3.4.4.6 Central Office (Type I) FSK Caller ID Expiration
Description: Specifies the duration in milliseconds that FSK Type I Caller ID information stays
valid. This configuration option is only enabled when the Central Office Caller ID Type is Bellcore
FSK.
Allowed Values: 100 to 60000 milliseconds
Default Value = 10000 milliseconds
INI File Parameter Name = telAlgTypeICidExpMs
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
Parameter Reference
61