Configuring The Media Gateway; Setting The Ip Address - Dialogic DMG1000 User Manual

Configuring the Media Gateway

Information about configuring, and upgrading the Dialogic
and Dialogic
•

Setting the IP Address . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35

• Basic Configuration Via the Serial Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
Changing the Password . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
•
• Configuration Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
• Restart Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38
• Importing and Exporting Configuration Information . . . . . . . . . . . . . . . . . . . . . . . . . . 38
Upgrading the Software. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40
•
Note: Refer to the Getting Started Guide for information about initially logging on to the Media Gateway
and performing basic configuration via the serial port.
2.1 Setting the IP Address
Once the IP address of the Media Gateway unit has been configured through the Web interface, the
unit must be restarted to activate the new configuration. The Media Gateway unit will then be
accessible to the Web browser at the newly configured IP address. All configuration parameters are
saved in the Media Gateway's non-volatile memory.
Use the following steps to assign the Media Gateway a unique IP address:
1. Select the IP configuration Web page from the Configure menu on the left side of the Web
page.
2. Change the unit's IP address from the default address by entering the new IP address in the
Client IP Address box.
3. Configure the subnet mask if it is different from the default value by entering the new subnet
mask in the Client Subnet Mask box.
4. Configure the IP address of the default network gateway router by entering the IP address in
the Default Network Gateway Address box.
5. Click on the Apply Changes button to save the configuration in the database.
Note: Refer to Chapter 3, "Parameter Reference"
that may be changed.
6. For the configuration change to take effect, you will be prompted to restart the Media Gateway
by clicking on Restart on the Web page or by selecting Restart from the Configuration menu.
7. When the Restart Web page appears, click on Restart Unit Now to restart the Media
Gateway.
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
2000 Media Gateway (DMG2000) is contained in the following sections:
®
1000 Media Gateway (DMG1000)
®
for a description of all of the configuration parameters
2
35