Pbx Self Verification Test Operation - Dialogic DMG1000 User Manual

9.3.1.2 Restrictions
The PBX self verification diagnostic is currently only available on PBX interfaces and protocols
that allow the interfaces and channels to be individually assigned extension numbers and allows
outbound and inbound call routing from one interface and channel to another.
Note: The PBX self verification diagnostics is not available on any ISDN protocol.
9.3.1.3 Capabilities
The ability to route calls and send message waiting status updates through a particular PBX
interface and channel is determined by the capabilities, enabled state, and if the interface and
channel is in-service. If the interface and channel is not in-service or is not enabled, or it does not
support the capability for the requested action, then the interface and channel will not be used for
routing through the gateway and will not be included in a diagnostic test.
To view and modify the capabilities and enabled state on a PBX interface and channel navigate to
the Gateway -> Gateway Capabilities Web page on the Media Gateway.
9.3.1.4 Location
The PBX self verification diagnostic tool is only part of the suite of diagnostic utilities that can be
used to assist in recording, testing, and resolving configuration or compatibility issues.
The Media Gateway diagnostic utilities are accessible via the Web interface by selecting the
Diagnostics link on the left side menu of any Web page.
9.3.2

PBX Self Verification Test Operation

To operate the PBX self verification diagnostic tool, navigate to the PBX Self Verification tab via
the Media Gateway's user interface.
In the PBX Self Verification Test Configuration table:
1. Choose the diagnostic test to perform by selecting one of the options in the Test Selection
field. The default selection is the Initiate Call / Answer Call diagnostic test only, but all
diagnostic test calls can be selected to be executed as one operation.
2. If the Initiate Call / Answer Call or Transfer Call diagnostic tests are selected, fill in the
interface extension numbers of the interfaces that are to be included in the test.
3. If the Send Message Waiting Status diagnostic test is selected, fill in the Message Waiting
Extension Number field with the extension to send the status update requests.
Note: The Send Message Waiting Status diagnostic test does not allow individual interfaces
®
Dialogic 1000 and 2000 Media Gateway Series User's Guide — September 2007
Dialogic Corporation
• Initiate Call / Answer Call - Requires two valid interface extension numbers.
• Transfer Call - Requires three valid interface extension numbers and is executed with
the Initiate Call / Answer Call diagnostic test.
to be selected for inclusion/exclusion. The test will be executed on all available PBX
interfaces.
Diagnostics
205