Mazda CX-7 2007 Workshop Manual page 1740

DATA MONITORING AND RECORDING PROCEDURE
1. Connect the M-MDS or equivalent to the DLC-2
(16-pin).
2. After the vehicle is identified, select the following
items from the initialization screen of the M-MDS.
When using the IDS (notebook PC)
• Select the "Toolbox" tab.
• Select "DataLogger".
• Select "Module".
• Select "HEC".
When using the PDS (pocket PC)
• Select "Module Tests".
• Select "HEC".
• Select "DataLogger".
3. Verify the data monitor items.
Indication Item Table
Monitor item
IC_DTC_CNT
IC_ECT
IC_NUMKEYS
IC_ODO_CNT
IC_SPDMTR
IC_TACHO
End Of Sie
FUEL GAUGE SENDER UNIT REMOVAL/INSTALLATION[AWD]
WM: FUEL GAUGE SENDER UNIT
Fuel Gauge Sender Unit
1. Remove the fuel gauge sender unit. (See 01-14-11 FUEL PUMP UNIT REMOVAL/INSTALLATION[L3 WITH
TC])
2. Install in the reverse order of removal.
Fuel Gauge Sender Sub-Unit
Warning
• Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and
damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line
Safety Procedure".
• Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and
damage. Fuel can also irritate skin and eyes. To prevent this, before performing the fuel pump unit
removal/installation, always complete the "Fuel Leak Inspection After Fuel Pump Unit
Installation".
• A person charged with static electricity could cause a fire or explosion, resulting in death or
serious injury. Before draining fuel, make sure to discharge static electricity by touching the
vehicle body.
Caution
• Because the fuel tank is constructed such that the fuel level is higher than the installation surface
of the fuel pump, fuel leakage could occur. If the fuel gauge indicates a fuel level of half or more,
perform the following Steps 1-6 to drain approx. 10 L {11 US gal, 8.8 lmp gal} of fuel.
• Disconnecting/connecting the quick release connector without cleaning it may possibly cause
damage to the fuel pipe and quick release connector. Always clean the quick release connector
joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is
free of foreign material.
• To prevent the SST from coming off the fuel pump cap while performing the work, always perform
the removal/installation procedure with 2 people. One person presses the SST against cap from
directly above, while the other person rotates the SST.
09-22–12
INSTRUMENTATION/DRIVER INFO.
Input-output signal/part
name
Number of continuous DTCs
Water temperature gauge
Number of key ID numbers
registered with the vehicle
Odometer
Speedometer
Tachometer
DLC-2
Unit/State
—
°C
—
m
KPH
RPM
id092200801500
acxuuw00001755
Terminal
—
2R, 2T
—
2R, 2T
id0922008019b4