Table of Contents
Advertisement
D.4
IP Network Change from the Initial Web Setup
D.4.1 Configure the modem
The modem must be configured with the correct network settings. Contact your network
administrator for an IP address mask, and modem, server and router IP addresses that are valid
for your network.
To recognize a subnet, each system in the subnet must have the same subnet mask. Set this
field before changing the Modem or Router Address. See Figure D-5.
1. Configure the modem with the new subnet addresses.
a. From the modem introduction page, click the IP ADMINISTRATION.
b. Enter your User Name and Password on the logon popup.
c. Press Enter.
d. Change the Boot Mode to NON-VOL.
e. Change IP addresses and subnet mask to the recommended settings.
f.
2. Otherwise, click Cancel any time to abort changes and reload the existing IP network
settings.
Appendix D
NON-VOL - stores and uses IP Mask and addresses.
Click Save to accept the changes.
Figure D-5. Modem Addressing Screen
DMD1050TS Satellite Modem Board
D–5
Revision 1
MN-DMD1050TS
Advertisement
Chapters
Table of Contents
