Chapter 7: Installing and Removing Internal Drives and Front Module Parts
Removing and Replacing the Plastics: Top and Base
190
To remove the plastics, top or base, you must shut down your system and remove the
bezel. Go to "Shutting Down and Powering Off the System" on page 161 and follow the
instructions through "Removing the Bezel" on page 162 Then return to this page.
Removing and Replacing the Top Cover
1. Locate the two top cover release areas, as shown in Figure 7-30.
2. Press on the two top cover release areas and hold.
3. While pressing inward on both areas, pull the top cover toward the front.
The top cover should slide forward.
If the top cover does not slide forward, press harder to release the catches, then slide
the cover forward.
Figure 7-30
Releasing the Plastic Top Cover