Figure 7-33 Releasing The Plastic Base; Figure 7-34 Sliding The Chassis Backward - Silicon Graphics OCTANE2 Owner's Manual

2. Use a flat-sided screwdriver to press down on the plastic release tab, as shown in
Figure 7-33.
Metal tab
Plastic release tab
Figure 7-33 Releasing the Plastic Base
3. While pressing down on the tab, slide the chassis back about 1-1/2 inches, until it
stops, as shown in Figure 7-34.
Figure 7-34 Sliding the Chassis Backward
Removing and Replacing the Plastics: Top and Base
193