Replacing The System Drive; Figure 7-14 Locating The System Drive - Silicon Graphics OCTANE2 Owner's Manual
Hide thumbs
Also See for OCTANE2:
- Owner's manual (306 pages) ,
- Installation manual (86 pages) ,
- Manual (144 pages)
Table of Contents
Advertisement
Installing and Removing Internal Drives
Replacing the System Drive
To replace the system drive, you must shut down your workstation and remove the
bezel. For more information, see "Shutting Down and Powering Off the System" on
page 161, then follow the instructions for "Removing the Bezel" on page 162.
Caution: Do not remove the system drive unless you have a new system drive to replace
it. A system drive must remain in place to prevent damage to the Octane2 workstation.
The SCSI ID of the system drive is 0-1.
Option drive bays
System drive
Light module
Figure 7-14
Locating the System Drive
173
Advertisement
Table of Contents
Need help?
Do you have a question about the OCTANE2 and is the answer not in the manual?
Questions and answers