Removing The Bezel; Figure 7-2 Locating The Lockbar On The Front Of The Octane2 Workstation - Silicon Graphics OCTANE2 Owner's Manual

Chapter 7: Installing and Removing Internal Drives and Front Module Parts
162

Removing the Bezel

Before you remove the bezel, shut down and power off your system, as described in
"Shutting Down and Powering Off the System" on page 161.
To remove the bezel, follow these steps:
1. Locate the lockbar, as shown in Figure 7-2.
If a lockbar is not installed, skip to step 4.
Figure 7-2 Locating the Lockbar on the Front of the Octane2 Workstation
Lockbar slot