Powering On The Octane2 Workstation; Figure 6-9 Powering On The Octane2 Workstation - Silicon Graphics OCTANE2 Owner's Manual

Chapter 6: Installing and Removing External Devices

Powering On the Octane2 Workstation

142
1. Plug in the power cable (see A in Figure 6-9).
2. Replace the lockbar (if one was removed).
Open the cover on the front of your workstation.
Slide the lockbar into the lockbar slot.
Insert the lock through the lockbar at the back of the workstation.
3. Press the power button (B) on your workstation.
4. Press the monitor power switch (C) to power on your monitor.
A
Power cable
Figure 6-9 Powering On the Octane2 Workstation
B
Power button
2
1
C
Power switch