Installing And Removing The Cpu And Memory; Figure 1-15 Powering On The Octane2 Workstation; Figure 1-18 Powering On The Octane2 Workstation - Silicon Graphics OCTANE2 Owner's Manual

Chapter 2
2.

Installing and Removing the CPU and Memory

This chapter shows you how to remove and install both the central processor unit (CPU)
and memory (DIMMs), which are located in the same area of your workstation. The
following topics are covered:
• "Preparing the Workstation" on page 32
• "Removing the System Module" on page 36
• "Removing and Replacing the CPU" on page 41
• "Installing and Removing Memory" on page 47
• "Reinstalling the System Module" on page 53
• "Powering On the Octane2 Workstation" on page 58
• "Verifying Memory Installation" on page 60
31