Figure 2-28 Placing The Primary Head Graphics Boards Toward The Top Of The; Workstation - Silicon Graphics Octane2 Manual

007-4209-003
Genlock
L
Swap
Ready
R
LATCH
UNLATCH
L
Swap
Ready
R
Genlock
Octane2 Dual Head with Dual Channel
Figure 2-28 Placing the Primary Head Graphics Boards toward the Top of the Workstation
Note: Be sure to install the Dual Head XIO Module in the orientation shown in
Figure 2-28. This orientation can be confirmed by ensuring that the silk-screened labels
on the I/O panel are right-side up, and that the center plastic knob is in the orientation
shown in Figure 2-28.
Dual Head XIO module
Slots A & B - primary head
XIO Module center knob
Slots C & D - secondary head
Reinstalling the Dual Head XIO Module
67