Installing The Frontplane Module; Figure 7-26 Tightening The Captive Screws On The Frontplane Module - Silicon Graphics OCTANE2 Owner's Manual

Chapter 7: Installing and Removing Internal Drives and Front Module Parts
186

Installing the Frontplane Module

Follow these steps to replace or reinstall the frontplane module:
1. Grasp the frontplane module by the metal frame on the edge of the front plane.
2. Lift the frontplane module into place and gently insert it into your workstation.
3. Tighten the six captive screws, as shown in Figure 7-26.
Figure 7-26 Tightening the Captive Screws on the Frontplane Module
4. Reinstall the system drive, as described in "Replacing the System Drive" on
page 173.
5. Reinstall any internal secondary drives, as described in "Installing Secondary
(Option) Internal Drives" on page 165.
6. Reinstall the light module, as described in "Removing and Replacing the Light
Module" on page 177.