Removing The Pci Module; Figure 4-6 Removing The Screws From The Pci Module; Figure 4-7 Opening The Release Lever - Silicon Graphics OCTANE2 Owner's Manual

Removing the PCI Module

To install or remove PCI boards, you must remove the PCI module from the workstation.
1. Loosen the two captive screws that secure the PCI module to the workstation, as
shown in Figure 4-6, until they are disconnected from the chassis.
Figure 4-6 Removing the Screws From the PCI Module
2. Pull the release lever toward you and to the right, as shown in Figure 4-7.
Release lever
Figure 4-7 Opening the Release Lever

Removing the PCI Module

75