Removing The Pci/Pci-X Support Bracket; Figure 4-3 Removing The Lower Pci/Pci-X Support Bracket - Silicon Graphics Prism Visualization System User Manual

Removing the PCI/PCI-X Support Bracket

007-4701-003
If you are accessing one of the two lower-most card slots (or the bottom card, in the case
of an XG2N module), you must remove the lower PCI/PCI-X support bracket that covers
the two lower-most slots. To do this remove the four Phillips screws, as shown in
Figure 4-3. (If you are not installing a card into one of the lower-most card slots you will
not need to perform this step.)
Figure 4-3 Removing the Lower PCI/PCI-X Support Bracket
Accessing the System's Internal Components
77