Vlan Commands; Gvrp And Bridge Extension Commands; Editing Vlan Groups - Supermicro SSE-G2252 User Manual

Chapter 36: VLAN Commands

GVRP and Bridge Extension Commands

36
GVRP B
AND RIDGE
VLAN C
OMMANDS
A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic VLAN
registration for the selected interface.
Table 36-1: VLAN Commands
Command Group Function
GVRP and Bridge Configures GVRP settings that permit automatic VLAN learning;
Extension Commands shows the configuration for bridge extension MIB

Editing VLAN Groups

Sets up VLAN groups, including name, VID and state
Configuring VLAN Configures VLAN interface parameters, including ingress and
Interfaces egress tagging mode, ingress filtering, PVID, and GVRP
Displaying VLAN Displays VLAN groups, status, port members, and MAC addresses
Information
Configuring IEEE 802.1Q Configures 802.1Q Tunneling (QinQ Tunneling)
Tunneling
Configuring L2CP Configures Layer 2 Control Protocol (L2CP) tunneling, either by
discarding, processing, or transparently passing control packets
Tunneling
a
across a QinQ tunnel
Configuring VLAN Maps VLAN ID between customer and service provider for
Translation networks that do not support IEEE 802.1Q tunneling
a
Configuring Configures protocol-based VLANs based on frame type and
Protocol-based VLANs protocol
Configuring IP Subnet Configures IP Subnet-based VLANs
VLANs
Configuring MAC Based Configures MAC-based VLANs
VLANs
Configuring Voice VLANs Configures VoIP traffic detection and enables a Voice VLAN
a. These functions are not compatible.
E C
XTENSION OMMANDS
GARP VLAN Registration Protocol defines a way for switches to exchange
VLAN information in order to automatically register VLAN members on
interfaces across the network. This section describes how to enable GVRP
– 1079 –