Logging Synchronous - Dell Force10 S4810P Reference Manual

Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.5.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage Syslog messages contain the IP address of the interface used to egress the router. By
Information configuring the logging source-interface command, the Syslog packets contain the
IP address of the interface configured.
Related
logging
Commands

logging synchronous

Synchronize unsolicited messages and FTOS output.
C-Series, E-Series, S-Series, Z-Series
Syntax logging synchronous [level level | all] [limit number-of-
buffers]
To disable message synchronization, use the no logging synchronous [level
level | all] [limit number-of-buffers] command.
Parameters
all
level
all
limit
buffers
Defaults Disabled. If enabled without the level or number-of-buffers options specified, level =
2 and number-of-buffers = 20 are the defaults.
Command Modes LINE
•
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
– enables logging to the Syslog server.
Enter the keyword all to ensure that all levels are printed
asynchronously.
level
Enter the keyword level followed by a number as the severity level.
A high number indicates a low severity level and visa versa. The
range is 0 to 7. The default is 2.
Enter the keyword all to turn off all.
number-of-
Enter the keyword limit followed by the number of buffers to be
queued for the terminal after which new messages are dropped. The
range is 20 to 300. The default is 20.
For VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.
1507