Save; Setenv - Dell Force10 S4810P Reference Manual

save

Save configurations created in uBoot.
S4810
Syntax save
Command Modes uBoot
Command History
Version 8.3.7.0
Usage You must save your changes before resetting the system or all your changes will be lost.
Information

setenv

Configure system settings.
S4810
Syntax setenv [gatewayip address | primary_image f10boot location |
secondary_image f10boot location | default_image f10boot
location | ipaddre address | ethaddr address | enablepwdignore
| stconfigignore]
Parameters
gatewayip
address
primary_image
secondary_image
default_image
location
Introduced on the S4810.
Enter the IP address for the default gateway.
Enter the keywords primary_image to configure the boot
parameters used in the first attempt to boot FTOS.
Enter the keywords secondary_image to configure boot
parameters used if the primary operating system boot selection is not
available.
Enter the keywords default_image to configure boot parameters
used if the secondary operating system boot parameter selection is
not available.
NOTE: The default location should always be the internal flash
device (flash:), and a verified image should be stored there.
Enter the location of the image file to be loaded. When using this
command, the keyword f10boot must precede the location. For
example, primary_image f10boot tftp://
10.10.10.10/server.
1575