Debug Vrrp - Dell Force10 S4810P Reference Manual

Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1

debug vrrp

Allows you to enable debugging of VRRP.
C-Series, E-Series, Z-Series
Syntax debug vrrp interface [vrrp-id] {all | database |interface ||
packets | state | timer}
To disable debugging, use the no debug vrrp interface [vrrp-id] {all |
database| interface| packets | state | timer} command.
Parameters
interface
vrrp-id
all
database
interface
packets
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the following keywords and slot/port or number information
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Port Channel interface types, enter the keywords port-
channel followed by the number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale.
• For a 40-Gigabit Ethernet interface, enter the keyword
FortyGigabitEthernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed by
the VLAN ID. The VLAN ID range is from 1 to 4094.
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
Enter the keyword all to enable debugging of all VRRP groups.
Enter the keyword database to enable configuration to change
information.
Enter the keyword interface to enable interface state to
information.
Enter the keyword packets to enable debugging of VRRP control
packets.
1615