Configuring Monitor Multicast Queue - Dell S6100 Configuration Manual

Dell(conf-mon-sess-1)#exit
Dell(conf)#do show monitor session
SessID Source
Gre-Protocol FcMonitor
------ ------
----------- ---------
0 Te 1/1/1/1
A N/A
0 Po 10
A N/A
1 Vl 40
A N/A
NOTE: Source as VLAN is achieved via Flow based mirroring. Please refer section
In the following example, the host and server are exchanging traffic which passes through the uplink interface 1/1/1/1. Port 1/1/1/1 is the
monitored port and port 1/1/2/1 is the destination port, which is configured to only monitor traffic received on tengigabitethernet 1/1/1/1
(host-originated traffic).
Figure 102. Port Monitoring Example

Configuring Monitor Multicast Queue

To configure monitor QoS multicast queue ID, use the following commands.
1 Configure monitor QoS multicast queue ID.
CONFIGURATION mode
monitor multicast-queue queue-id
Dell(conf)#monitor multicast-queue 7
2 Verify information about monitor configurations.
662 Port Monitoring
Destination Dir
----------- ---
Te 1/1/1/2 rx
No
Te 1/1/1/2 rx
No
Te 1/1/1/3 rx
No
Mode Source IP
---- ---------
Port 0.0.0.0
Port 0.0.0.0
Flow 0.0.0.0
Dest IP DSCP TTL
-------- ---- ---
0.0.0.0 0 0
0.0.0.0 0 0
0.0.0.0 0 0
Enabling Flow-Based
Drop Rate
---- ----
No N/
No N/
No N/
Monitoring.