Configuration File Handling Task List - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
• Default settings for the quality of service subsystem
As soon as a user-specific configuration is created and stored as the startup configuration, the factory configura-
tion is no longer used, but still remains in the persistent memory. At any time during the operation of a Smart-
Node it is possible to switch back to the factory configuration. The restoration procedure for restoring the
default settings is described in the getting started guide included with your SmartNode device.
Configuration file handling task list
This section describes how to create, load, and maintain configuration files. Configuration files contain a set of
user-configured commands that customize the functionality of your SmartNode device so as to suit your own
operating requirements.
The tasks in this chapter assume that you have at least a minimal configuration running on your system. You
can create a basic configuration file using the configure command; see section
uration at the CLI" on page 87 for details.
To display, copy, delete, and download or upload configuration files perform the tasks described in the follow-
ing sections:
• Copying configurations within the local memory (see
• Replacing the startup configuration with a configuration from Flash memory (see
• Copying configurations to and from a remote storing location (see
• Replacing the startup configuration with a configuration downloaded from TFTP server (see
• Displaying configuration file information (see
• Modifying the running configuration at the CLI (see
• Modifying the running configuration offline (see
• Deleting a specified configuration (see

Configuration file handling task list

Avoid downloading any configuration file if you do not com-
pletely understand what you have to do! If a configuration file
download fails or succeeds only partially your SmartNode device
cannot start up without a support intervention at the factory.
page
page 89)
page 82)
page 85)
87)
page 87)
page 88)
7 • Configuration file handling
"Modifying the running config-
page 83)
page 86)
81